目前行業中所生產的10kV及其以上的戶外高壓真空斷路器如果配彈簧操作機構都是具備手動和電動的儲能方式。所謂儲能就是在斷路器斷電時（即分閘時），由于儲能開關的彈簧的彈力而迅速分閘。斷路器分閘時當然越快越好，這樣是為了在分段故障大電流時，有足夠的力量分開觸頭（超大電流會將觸頭燒融在一起）。
儲能開關控制儲能電機啟停的。儲能電機的作用是帶動儲能機構壓縮合閘機構的彈簧，使合閘機構彈簧產生一定的壓縮能量，儲能電機停止工作，備用于需要合跳閘時之用。有些是自動儲能的，當接通電源時儲能開關就會自動儲能。儲能完畢就會斷開觸點。有些帶有開關控制的可以選擇手動儲能和自動儲能。 儲能開關只是用于開關在失去外部電源時做合閘使用的。它不使用于分閘操作。所以關掉儲能開關電源后，儲能開關設備不會斷開，只是關掉后他不會儲存能量了。
; 至于為什么戶外高壓真空斷路器一定要可以儲能，是因為一般的戶外高壓真空斷路器都要求具備自動重合閘功能:分閘后，可以立刻再合閘。 所以斷路器在合閘后(能量釋放)后，必須立刻重新儲能，為下次合閘作準備。如果手動和電動都不行則說明此彈簧操作機構存在問題，針對你反應的問題，建議你打開一下操作面板，再手動儲一下能，看一下是不是有明顯的部件破損或其它非機構部件卡在傳動位置上。
;這里需要特別注明的是：高壓真空斷路器儲能與手動分閘儲能在智能控制單元內合上輔助電源開關給智能控制箱內蓄電池充電，如果蓄電池已充電時可以將智能控制箱內的蓄電池開關合上，等待20s此時儲能電容器已充電，高壓真空斷路器已處在準備操作狀態。手動分閘操作真空斷路器處在合閘位置，用絕緣操作棒鉤住斷路器手動分閘操作把柄上的拉環，并向下拉動，斷路器即可分閘，并且仍具有一定的分閘速度，可保證斷路器能可靠地開斷額定負荷電流。
